Shenzhen Jun Tai Feng Novel Material co., ltd



Washing wall lamp Potting glue

Shenzhen Jun Tai Feng novel material co., ltd

Tel: 0755-29694891 0755-29694892

Fax: 0755-29694893



Address: Shenzhen Bright new District, public-ming potato field PO Community Emerging Industrial Zone A, the first second floor 201

Washing wall lamp Potting glue
Abstract: JTF-XQD-106 Series room temperature curing silicone wall-washing lamp potting Sealant

First, use:

jtf-xqd-106A series of room temperature curable silicone wall washer lampPotting GlueMainly in the company for the LED display packaging and development of special potting gum, this glue has excellent waterproof and heat dissipation, to maximize the guarantee of the service life of lighting.

Second, function and characteristics:

JTF-XQD-106 series Washing wall lamp potting glue is mainly used for the LED screen potting its main functions are as follows:

1, it has excellent waterproof nature, can protect the lighting and electrical components are not water immersion erosion;

2, with excellent heat dissipation, can ensure that the chip in the use of the process will not be due to excessive temperature and affect the service life;

3, with super Anti-ultraviolet ability, to ensure that the lighting in its service life encapsulation with glue never brittle;

4, with excellent weather performance, to ensure that lighting and electrical components in a wide range of temperature ( -40~220℃) and underwater, such as the normal use of special circumstances, so that the use of lighting area almost unlimited;

5, this series of products are cured at room temperature, the main curing mechanism is with the air moisture reaction and curing, so the temperature is not sensitive, so that its curing conditions require simpler, easier to operate.

Third, the use of specifications:

Four, wash wall lamp potting glue use method:

1, with glue, this series of glue are two-part liquid, the use of two parts in accordance with 10:1 of the proportion of mixing, and mixing equipment to fully stir (be sure to ensure that two parts mixed evenly), note: Must ensure that the mixing rod and the container cleaning (not with the rest of the glue contact);

2, vacuum, after the glue will be placed in the bubble-blowing device for bubble treatment, because the silica gel molecular tension is small, so in the vacuum when the bubble is very easy to accumulate, you can see a lot of bubbles very fierce platoon out. So in order to avoid the waste of glue, in the vacuum, as many times as possible in the discharge valve place gas;

3, after the elimination of bubbles, you can transfer glue into professional potting equipment for drip irrigation;

4, after the drop gum, placed 5-6 hours or so, when the surface does not stick to the hand (after the full table dry) can be packaged.